Capacity : 715 gpm (45.1 lps)
Head : 59 ft (17.9 m)
Standard (4V) and Explosion-Proof (4VX) Construction
The 4V and 4VX (Explosion-proof) Submersible Wastewater Pumps pass a full 3" spherical solid and are the ideal choice when selecting a pump for your next application. Myers rounded port, 2-vane, enclosed impellers prevent solids from binding or clogging and offer high operating efficiencies to cut your pumping costs. The 4V series modified constant velocity volute case provides smooth operation over an extended portion of the performance curve for longer seal and bearing life. For use in municipal lift stations, treatment plants and industrial waste applications. Myers offers a complete line of wastewater pumps, lift-out rail assemblies, controls and accessories to meet your needs.
Advantages By Design
High efficiency hydraulic design cuts pumping costs and extends life of fluid end components.
Head : 59 ft (17.9 m)
Standard (4V) and Explosion-Proof (4VX) Construction
The 4V and 4VX (Explosion-proof) Submersible Wastewater Pumps pass a full 3" spherical solid and are the ideal choice when selecting a pump for your next application. Myers rounded port, 2-vane, enclosed impellers prevent solids from binding or clogging and offer high operating efficiencies to cut your pumping costs. The 4V series modified constant velocity volute case provides smooth operation over an extended portion of the performance curve for longer seal and bearing life. For use in municipal lift stations, treatment plants and industrial waste applications. Myers offers a complete line of wastewater pumps, lift-out rail assemblies, controls and accessories to meet your needs.
Advantages By Design
High efficiency hydraulic design cuts pumping costs and extends life of fluid end components.
- Two-vane, rounded port, enclosed type impellers handle 3" solids with ease at high operating efficiencies.
- Modified constant velocity volute offers quiet operation, low radial loads over extended portion of performance curve.
- Oil-filled motor for maximum heat dissipation and constant bearing lubrication.
- Heat sensor thermostats imbedded in windings protect motor from overheat conditions.
- Seal leak probe in seal chamber warns of moisture entry; helps prevent costly motor burnout.
- Double tandem shaft seals prevent sewage from entering motor.
- Power and control cables are double sealed with epoxy and compression grommet.
Unit of Measure
Specifications
Head |
N/A 59 ft17.9 m |
Solids Handling (Diameter) |
N/A 3 in76 mm |
Liquids Handling |
N/A Effluent Raw Unscreened Sewage Storm Water |
Intermittent Liquid Temperature |
N/A up to 140 ºFup to 60 ºC |
Winding Insulation Temperature. (Class F) |
N/A 311 ºF155 ºC |
Motor Electrical Data1 |
N/A
1150 RPM 1-2 HP, 200/230V, 1Ø, 60 Hz and 208/230/460/575V 3Ø, 60 Hz 1750 RPM 3-5 HP, 230V, 1Ø, 60 Hz 3-10 HP, 200/230/460/575V 3Ø, 60 Hz |
Acceptable pH Range |
N/A 6 to 9 |
Specific Gravity |
N/A 0.9 to 1.1 |
Viscosity |
N/A 28 to 35 SSU |
Horizontal Discharge Flanged Centerline |
N/A 4 in. 125 lb ANSI 101.6 mm |
Power |
N/A 3 hp |
Voltage |
N/A 230 V |
Phase |
N/A 1 |
Frequency |
N/A 60 Hz |
Start |
N/A 60 A13.8 kV·A |
Run |
N/A 21.0 A3.8 kW4.8 kV·A |
NEC Code Letter |
N/A H |
Service Factor |
N/A 21 A3.8 kW1.0 |
Capacity |
N/A 715 gpm45.1 lps |
Note |
N/A Consult factory for applications outside of these recommendations. |
Construction Material
Motor Housing Material |
N/A Cast Iron, Class 30, ASTM A48 |
Seal Housing Material |
N/A Cast Iron, Class 30, ASTM A48 |
Volute Case Material |
N/A Cast Iron, Class 30, ASTM A48 |
Cord Cap Material |
N/A Cast Iron, Class 30, ASTM A48 |
Enclosed 2-Vane Impeller Material |
N/A Ductile Iron, Class 65, ASTM A536 |
Power Cord Material |
N/A 25 ft. SOOW |
Control Cord Material |
N/A 25 ft. SOOW |
Standard Double Tandem Mechanical Seal Material |
N/A Carbon & Ceramic, Type 21 |
Optional Double Tandem Mechanical Seal Material |
N/A Lower Tungsten, Carbide |
Pump Shaft Material |
N/A 416 SST |
Motor Shaft Material |
N/A 416 SST |
Fasteners Material |
N/A 300 series SST |
Volute Wear Ring Material |
N/A Brass |
- 1 Single phase motors are capacitor start type. Myers control panels or capacitor kits are recommended for proper operation and warranty.